Engineered Cleaning Solutions for Polymers
USA DeBusk uses specially designed high-pressure hydro blasting/cutting tools to mechanically clean lines, loop reactors, vessels and heat exchangers in polyethylene plants. We make cleaning efficient through basic engineering:
Increasing the volume of water used in cleaning to the maximum capacity of the hoses
Specifying the largest hoses possible
Employing nozzle rotation to enhance effectiveness
Adding multiple cleaning heads and multiple lances whenever possible
Using the latest technology in nozzle designs to generate the fine, high-precision water stream needed to cut plastic
Proprietary mechanical abrasive cleaning
Lines & Loop Reactor Cleaning
These photos show piping before (left) when pipe walls were coated with a thin layer of white plastic and after (right), when it was cleaned to bare metal.
For heat exchangers in polyethylene plants, we use multiple lances whenever possible.
This photo shows a triple rotary lancing machine operating at a polyethylene plant.
The exchanger was completely plugged with plastic. Our crew used a 70-foot-long tube lancer operating at 40,000 psi to clean the exchanger.
Reducing the cleaning time was critical and our team completed the job and allowed the exchanger to return to service within the least amount of time.
In polyethylene units, vessels can become filled with plastic. To clean them, USA DeBusk uses automated hydro blasting equipment and the most technically advanced nozzle designs that efficiently remove polymer material.
Extremely high water volumes and pressures minimize cleaning time. Standard cleaning involves using 40,000 psi pressure with hydro blasting specialists entering the vessel to perform the cleaning.
Projects can also be completed using rotating 3-D nozzles that eliminate hand cleaning and allow continuous operation. To achieve the high volumes and pressures necessary, we use pumps with up to 2,500 hp.